Design and Analysis of Aqua Silencer for Reducing Exhaust Emission Control

Surajkumar Khapare, Balkunde pratik, Bhure shashank, Bharambe Tejas, Devkar Kamlesh
Journal of Thermal and Fluid Science
Volume 2: Issue 2, July 2021, pp 50-54

Author's Information
Surajkumar Khapare1 
Corresponding Author
1Assistant Professor, Assistant Professor, Department of Mechanical Engineering, JSPM Narhe Technical Campus, Pune, Maharashtra, India
surajkumarkhapare@gmail.com

 Balkunde pratik2, Bhure shashank2, Bharambe Tejas2, Devkar Kamlesh2
2Student, Assistant Professor, Department of Mechanical Engineering, JSPM Narhe Technical Campus, Pune, Maharashtra, India

Research Paper -- Peer Reviewed
Published online – 15 July 2021

Open Access article under Creative Commons License

Cite this article – Surajkumar Khapare, Balkunde pratik, Bhure shashank, Bharambe Tejas, Devkar Kamlesh, “Design and Analysis of Aqua Silencer for Reducing Exhaust Emission Control”, Journal of Thermal and Fluid Science, RAME Publishers, vol. 2, issue 2, pp. 50-54, July 2021.
https://doi.org/10.26706/jtfs.2.2.20210603

Abstract:-
The exhaust pipe is equipped with an aqua silencer. CO, UBHC, NOx and Lead constitute the primary pollutants that cars contribute. Sound beneath water that is created in the atmosphere is less perceptible than the sound. This is mainly due to tiny water molecules sprockets, which reduce its amplitude, which lessens the loudness of the sound. This damaging nitrous and Sulphur content generated by the motor is filtered by the activated carbon layer. It converts high mass bubbles to low mass bubbles and lowers noise emissions. This silencer requires water and is hence called AQUA SILENCER. The aqua Silencer is used for noise reduction and management of harmful gas emissions in vehicles.
Index Terms:-
Pollution, Aqua silencer, Charcoal layer, Reduce noise.
REFERENCES
  1. Mankhiar Ajay B , Sindhu L S,G Sasikala, “An Advancement to Reduce Pollution Effectively by Using TI Nano tubes in Aqua Silencer”, International Journal of Engineering Sciences and Research Technology, 2014
  2. Rawale Sudrshan S & Patil S Nehal S, “Use of aqueous Ammonia in Silencer for removal of CO2,SO2 and NOx from exhaust gases of IC Engines”, International Journal of Engineering Science and Innovative Technology,Vol.2, Issue 5, 2013.
  3. D. R. Bele K. S. Rambhad, Ankita Patil, Concept of Jigs and Fixture Design –A Review, International Journal of Analytical, Experimental and Finite Element Analysis (IJAEFEA), Issue. 4, Vol. 4, Dec 2017 e-ISSN: 2394-5141, p-ISSN: 2394-5133, pp 73-77.
  4. Swastik R , (July 2014) “Design and Development of Aqua Silencer for Two Stroke Petrol Engine”, International Journal for Innovative Research in Science and Technology, Vol.1, Issue 1.
  5. Kishor Rambhad, Mahesh Thigale, Venkateshwara Sutar, Pradip Sonwane, Shubham Suryawanshi, A Review on Automotive Bumper Beam Design and Analysis, Journal of Automotive Engineering &Technology Volume 5 Issue 1, 2020, Page 18-35.
  6. Balashanmugam P , Balasubramanian,(January 2015) “Developments of Emission and Noise Control Device ”, International Journal of Modern Trends in Engineering and Research,Vol.02,Issue 01.
  7. K. S. Rambhad, Amit N. Borugale, Shubham N. Khandre, Akshay S. Kale, Aniket P. Shinde, Experimental Analysis of Hydraulic Oil Cooler by Application of Heat Pipe, International Journal of Analytical, Experimental and Finite Element Analysis (IJAEFEA), Issue. 2, Vol. 6, May 2019 e-ISSN: 2394-5141, p-ISSN: 2394-5133, pp 49 – 52.
  8. Amruthraj M, Nataraj J.R. & Sushmit Poojary, (October 2012) “Emission Control in IC Engines”, International Journal of Engineering Research Abd Development, Vol .4, Issue 4.
  9. K. Kannan & M. Udayakumar, (October 2009) “NOx and HC Emission Control Using Water Emulsified Diesel in Single Cylinder Diesel Engine”, ARPN Journal of Engineering and Applied Sciences, Vol.4, No 8.
  10. Mahesh Shende, Shubham Parchand, K. S. Rambhad, P. P. Shingare, A. Sridhar5, Development of Mechanisms for Removing Excess Laminated Paper, International Journal of Analytical, Experimental and Finite Element Analysis (IJAEFEA), Issue. 4, Vol. 4, Dec 2017 e-ISSN: 2394-5141, p-ISSN: 2394-5133, pp 84-87.
  11. Guromoorthy S. Hebbar & Anantha Krishna Bhat, (July-Aug. 2012) “Diesel Emission Control by Hot EGR and Ethanol Fumigation; an Experimental Investigation”, International Journal of Modern Engineering Research, Vol.2, Issue.4, pp-1486-1491.
  12. N. T. Parshuramkar, K. S. Rambhad, R. Chandran, Welding Spatter Reduction and Time Study: A Review, International Journal of Analytical, Experimental and Finite Element Analysis (IJAEFEA), Issue. 4, Vol. 4, Dec 2017 e-ISSN: 2394-5141, p-ISSN: 2394-5133, pp 88-90.
  13. Prabavathi Nagarajan & Priscilla Prabavathi,( November 1999) “ A Study of removal of Pb (II) by adsorption technique using carbonized tamarind seed”, Indian Environment. Prot. 25(5): 433 43

    14. To view full paper, Download here


To View Full Paper

For authors

Author's guidelines Publication Ethics Publication Policies Artical Processing Charges Call for paper Frequently Asked Questions(FAQS) View All Volumes and Issues

Publishing with